Influência de escâneres CAD/CAM na adaptação marginal de infraestruturas em zircônia implanto-suportadas

Abstract

The purpose of this study was to compare the fit accuracy of CAD/CAM- fabricated zirconia frameworks using two different scanners and the same milling unit by scanning electron microscopy (SEM). Material and methods. Ten 3-unit implant-supported, screw-retained frameworks were fabricated to fit a mastermodel. The same manufacturing milling unit fabricated all the frameworks using two scanners, five frameworks for each group: 7series Dental Wings and Ceramill map 400. The vertical and horizontal misfit at the implant-framework interface (mesial and distal of all implants) were measured by SEM resulting in 30 measurements per group (n=30) when only 1 screw was tightened and after all screws were tightened. The statistical analysis was performed using Mann-Whitney test (a=.05) by vertical misfit. Horizontal misfit values were separated in three situations: underextension, zero and overextension. Results: Significant difference was found between the fit accuracy of the two groups when all screws were tightened, however all values is below 16 pm. Five and eighteen horizontal misfit were found in Dental Wings and Ceramill map 400, respectively. Conclusions: The use of different scanners have influence on fit accuracy of zirconia frameworks.